Protocolo Péptidos Request protocol →ES · EN
Research reference · 100 mg vial

AHK-Cu dosage & reconstitution (100 mg vial)

AHK-Cu dosage: calculations for a 100 mg vial use the same amounts described in the literature. Adding 3 mL of bacteriostatic water produces 33.33 mg/mL, so each U-100 unit contains 333 mcg.

01

AHK-Cu Quick Reference (100 mg vial)

Vial contents100 mg AHK-Cu
Final volume3 mL
Concentration33.33 mg/mL
One U-100 unit333 mcg in 0.01 mL
AHK-Cu 100mg

Research context: mechanisms, human and preclinical evidence, limitations and precautions are in How this works and References. The calculator (Spanish) converts any other volume.

02

AHK-Cu Dosage Chart (100 mg vial)

No published clinical trial establishes a dosing regimen for AHK-Cu. Any figure circulating as a human protocol does not come from an indexed trial. This site does not publish doses without a verifiable source.

U-100 Conversion Table (3 mL = 33.33 mg/mL)

U-100 unitsVolumeContainsYield per vial
20.02 mL666.667 mcg149 injections
50.05 mL1.66667 mg (1667 mcg)59 injections
100.10 mL3.33333 mg (3333 mcg)29 injections
200.20 mL6.66667 mg (6667 mcg)14 injections
300.30 mL10 mg (10000 mcg)9 injections
500.50 mL16.6667 mg (16667 mcg)6 injections
1001.00 mL33.3333 mg (33333 mcg)3 injections

Reconstitution Steps

  1. Draw 3 mL of bacteriostatic water with a sterile syringe.1
  2. Inject slowly down the vial wall; avoid shaking to prevent foaming.2
  3. Gently swirl or roll until fully dissolved (clear solution).3
  4. Label with the reconstitution date and refrigerate at 2–8 °C, protected from light; use within 4 weeks.4
03

Supplies Needed

Per 100 mg vial: 3 mL of bacteriostatic water, one U-100 syringe per injection (plus one to reconstitute) and two alcohol swabs per injection.

AHK-Cu 100mgView in store
U-100 syringes (1 mL)1 mL, fine needle
Bacteriostatic water 3 mLView in store
Alcohol swabs70 % isopropyl

Store links may earn a commission. A supplier page is not scientific evidence or proof of suitability for human use.

04

AHK-Cu Vial and Research Context

  • Reconstitute: add 3 mL of bacteriostatic water to produce 33.33 mg/mL.
  • Easy measuring: 1 U-100 unit = 0.01 mL = 333 mcg.
  • Vial size: the 100 mg label is total nominal content, not a per-injection amount.
05

Storage Instructions

  • Lyophilized (unopened): −20 °C for long-term storage; 2–8 °C if used within weeks. Protected from light.
  • Reconstituted: 2–8 °C, do not freeze. Use within the documented period (typically up to 4 weeks with bacteriostatic water).
  • Handling: do not shake; avoid temperature cycling; label with date and concentration.
  • Discard: cloudy solutions, particulates or expired preparations are discarded.

More detail in the storage guide (Spanish).

06

Important Notes

  • Research only: the referenced compounds are sold for laboratory research. Nothing here is medical advice or an administration schedule.
  • Above 100 units: a 1 mL U-100 syringe cannot hold them; split across syringes or reconstitute with less volume.
  • Accuracy: concentration depends on the actual volume added; measure the diluent with a syringe, not by eye.
  • Verification: confirm vial contents against the batch certificate of analysis before calculating.
07

How This Works

AHK-Cu is the synthetic tripeptide Ala-His-Lys (Alanyl-Histidyl-Lysine) complexed with copper (II), presented as a 100 mg lyophilized research vial. The literature documents it in hair follicle and dermal matrix studies as a copper complex associated with cell proliferation signaling.

Signaling pathways documented in the literature:

  • Follicle stimulation Ex vivo models of human hair follicles document elongation and proliferation of dermal papilla cells
  • Copper Signaling: The copper (II) complex is associated in literature with extracellular matrix modulation and dermal angiogenesis
08

Research Applications

  • Pyo HK et al., Biol Pharm Bull 2007 (PMID 17703734): AHK-Cu in in vitro human hair follicle growth and dermal papilla cell proliferation studies
  • Pickart L, Margolina A, Int J Mol Sci 2018 (PMID 30041448): Copper peptide review in dermal remodeling and extracellular matrix

Research material only. No FDA-approved human use. Information is provided for educational and scientific literature reference purposes.

09

Injection Technique in Research

  • Route in the studies: subcutaneous, in abdominal or thigh adipose tissue, rotating the site.
  • Syringe: 1 mL U-100 (100 units); read in units, not mL.
  • Asepsis: alcohol swab on the stopper and the site; a new syringe per injection.
  • Drawing: purge air, draw the units from the chart and verify before withdrawing the needle from the vial.

Full guide: U-100 syringes and reading units (Spanish).

10

Research Note

All content on this page is technical and educational. It describes how a vial is reconstituted, how a syringe is read and which amounts the cited sources describe. It does not replace the supervision of a qualified researcher or the judgment of a health professional, and it is not intended to diagnose, treat, cure or prevent any disease.

11

Related Protocols

Research material only. Technical and educational content. Not medical advice, an administration schedule or a recommendation for use, and not intended to diagnose, treat, cure or prevent any disease. The referenced compounds are sold for laboratory research.

This site is an independent publication. Supplier links may earn a commission.